Some people have problems using multiple effects through one amp because they use certain ones for thier clean tones and certain ones for thier dirty tones. When they switch to dirty, they have to stomp the clean effects "off" and the dirty effects "on". That's a lot of fancy footwork that not necessary. Solution?, enter the "Clean/Dirty Effects Switcher
Stump the crowd and your friends into looking for that second amp!! This is similiar to the Double-loop true bypass pedal but it needed to be classified a little different.
EXAMPLES: Put a Chorus, and Compressor in one loop then, put an Overdrive, Flanger, and Phaser in the other loop. Turn them ALL on and listen as you switch from a clean, compressed, chorused guitar to an overdriven, phased, flanged guitar signal with the click of one switch into one amp!! And if you have an effect that you use for both clean and dirty, (like a delay) just run it before or after the Clean/Dirty Switcher and it'll be on no matter which loop you have activated.
INGREDIENTS: "High Gloss" clear coating, Heavy-Duty Die-Cast Aluminum enclosure, (1) 3PDT switch, (6) Switchcraft #11 jacks, DC Jack for 9 volt power, and Extra Heavy-Duty 22 Gauge Silver Plated Military Spec. Wiring.
LEDS: For the 9V DC Jack, these units require a 9V AC adapter with a Boss/Ibanez style 2.1mm barrel plug. If you do not have one, we have these in the "Accessories" section. (Unit will work without LED's. The LED circuit in any loop-Master unit does not affect tone.)
DIMENSIONS: MXR-Sized, 4.3" X 2.3" X 1.2" (MXR-Sized)