Change from one group of effects to another group of effects in A/B
fashion and change the channel on your two channel amp (Amps with 1/4" mono jacks for channel switching) all at the same time. Step on the "loop
1+2" switch to combine loop
s with either channel at any time. Step on the "Bypass" to bypass any loop
or both loop
s at anytime and with the "Tuner" switch, tune silently at any point by plugging your favorite tuner in the "Tuner" jack on back.
Say you want an EQ to come on only on the drive channel of your amp and a chorus and delay to come on only on the clean channel of your amp.
Connect the EQ in loop 1 and the chorus and delay in loop 2.
Connect a 1/4" mono cABle to your channel switching jack on your amp to "Channel" on the loop-Master.
If the effect(s) that you want in one loop are on but is on the wrong channel, flip the "Line Polarity" switch once and you're calibrated.
Again, works with any amp that requires a single 1/4" mono cABle for switching channels. If in doubt, see your amp dealer or contact your amp manufacturer. (If you have an amp that uses TRS, you will need a stereo cABle and a stereo to dual-mono connector for this to work. Let me know if you need either or both items)
Will also work as a stand alone channel Switcher or a stand alone Clean/Dirty Switcher.
DIMENSIONS: 10" X 2.2" X 1.6".
LEDS: For the 9V DC Jack, these units require a 9V AC adapter with a Boss/Ibanez style 2.1mm barrel plug. If you do not have one, we have these in the "Accessories" section. (Unit will work without LED's. The LED circuit in any loop-Master unit does not affect tone.)